Search:

I will leave well enough alone. Thank You

I am sure that they are the same cut. I will leave well enough alone. Thank You

I will, thank you.

I just use it for pleasure and it is over 400 HP. I have the steel in it now. I was wondering if I should go to aluminum. I have both.

Go with the diverter. The trim will make the boat ride better and faster. Also and the rooster tail will make you smile.

I have a impeller question. Which is best for my boat a steel or aluminum impeller?
Any help would be appreciated
Thanks Dave.

I am using a Holly 780 and have no problems.

I had a very similar problem last summer and it ended up being a bad fuel pump. It would run at low speeds but when I wanted to jump it up it would not take it. Good Luck

Ok took my 75 glastron out this past weekend and it ran great at half throttle ....but when u cracked down on it ...it would fall on its face at full throttle ...and put and sputter what can I check...

The site is VINTAGE. That is not anywhere near. It is different.

http://www.youtube.com/watch?v=W7rAVTPIS80#

Great decal - Thanks - Now all I need to do if afford gas for the beast. My wife has nick named the boat The EFFIN boat for obvious reasons. Thanks again. I will try to post a picture. Later Dave