PDA

View Full Version : Inline Sanding Paper Life



77GT
04-03-2011, 01:39 PM
I have been using an air powered inline sander while working on the inside of the hull.

The problem I had was paper life or lack of life.

The paper would tear at the ends long before it was worn out.

Sometimes the paper would tear after a couple of minutes.

I came up withthe solution.

I lined the back of the sand paper with a piece of duct tape.

I have used the same sheet of paper for an hour or so and it has not torn and it is not worn out.

David
04-03-2011, 02:51 PM
Nice one....

78_Tahiti
04-03-2011, 03:42 PM
Very good call! I may think about getting one now! I always thought those were a little hard on paper! lasts long time on my D.A. That is unless your trying to sand the brushed grain off of stainless!